Command Outdoor Light Clips Instructions

Command Outdoor Light Clips offer a convenient and damage-free solution for hanging outdoor string lights, holiday decorations, and other lightweight items. These clips feature a strong adhesive that adheres securely to most outdoor surfaces, including brick, stucco, wood, and vinyl siding. The clips are also weather-resistant, making them suitable for use in all types of outdoor environments.

This article will provide a comprehensive guide to using Command Outdoor Light Clips, covering installation, removal, and troubleshooting tips.

Installing Command Outdoor Light Clips

Installation of Command Outdoor Light Clips is a simple process that can be completed in a few minutes. The following steps will guide you through the installation process.

Clean the surface:
Begin by cleaning the surface where you intend to install the clips. Use a mild detergent and a soft cloth to remove any dirt, grime, or debris. Ensure the surface is completely dry before proceeding.
Select the location:
Choose the desired location for your clips, keeping in mind the weight of the items you plan to hang. Ensure the surface is smooth and even. You can use a level to ensure that the clips are installed straight.
Peel the adhesive backing:
Peel off the protective paper backing from the adhesive strip on the back of the Command Outdoor Light Clip. Avoid touching the exposed adhesive with your fingers, as this can reduce its effectiveness.
Press firmly for 30 seconds:
Press the clip firmly onto the cleaned surface for at least 30 seconds to ensure a strong bond. Avoid moving the clip once it has been pressed down.
Wait for the adhesive to set:
Allow the adhesive to set for at least one hour before hanging any items on the clips. This will give the adhesive sufficient time to cure and provide maximum holding strength.

Removing Command Outdoor Light Clips

Removing Command Outdoor Light Clips is equally straightforward. The following instructions will ensure that you remove the clips without causing any damage to the surface.

Locate the release tab:
Find the small release tab located on the back of each Command Outdoor Light Clip.
Press and pull:
Gently press the release tab and simultaneously pull the clip away from the surface. The adhesive should detach cleanly from the surface without residue.
Remove any remaining adhesive:
If any adhesive residue remains on the surface, gently remove it with a soft cloth or a rubber eraser. Do not use sharp objects or abrasive cleaners, as these can damage the surface.

Troubleshooting Command Outdoor Light Clips

While Command Outdoor Light Clips are designed for strong adhesion, there may be instances where the clips do not adhere securely. The following troubleshooting tips can help address common issues.

Ensure surface cleanliness: Make sure the surface is thoroughly cleaned and dry before installing the clips. Any residue or moisture can interfere with the adhesive bond.
Avoid extreme temperatures: Command Outdoor Light Clips are designed for use in a wide range of temperatures, but it is best to avoid installing them during extreme heat or cold, as these conditions can affect the adhesive's performance.
Inspect for damage: If the clips are damaged or appear to have lost their adhesive strength, replace them with new ones.
Choose the appropriate clip size: Select the appropriate clip size for the weight of the items you plan to hang. Overloading the clips can reduce their holding strength.

By following these instructions and troubleshooting tips, you can confidently use Command Outdoor Light Clips to hang your outdoor lights and decorations with ease and without causing any damage to your property. These clips offer a versatile, convenient, and damage-free way to add a touch of ambiance to your outdoor space.